Digital Water Bath, 2 L
Product Code : EL-LWB-11102
Last updated: 6 October 2026
Quick answer: A 2 litre digital water bath for a crowded bench, with a stainless-steel chamber, ambient +5 to 100 degrees C, +/-0.2 degrees C at 37 degrees C, 0.1 degree increments, in-lab calibration and a see-through cover. Weight 4-1/2 lb.
The accuracy figure is the reason to choose this over the analogue bath in this family: +/-0.2 degrees C at 37 degrees C, set in 0.1 degree increments on a large three-digit display, against +/-0.5 degrees on a knob. For enzyme incubations where a couple of degrees changes the activity, that difference is the experiment.
The range runs to 100 degrees C, so unlike the 9 litre analogue bath this one will reach boiling for denaturation steps.
Practical details are well handled for a small instrument. The chamber is stainless steel, easy to clean and long-lasting. The insulated housing holds temperature while staying cool to the touch, which matters on a crowded bench where a hot casing is a burn risk. The cover is flat, removable and see-through, so samples can be watched without lifting it and losing heat. In-lab calibration means the bath can be corrected against a reference thermometer without being sent away.
The size is the point: exterior 6-1/2 x 8 x 6 inches with a 5-1/2 x 6 x 4 inch chamber, at 4-1/2 lb. That fits where a larger bath will not, at the cost of holding only a few tubes at a time. No tube racks are mentioned as supplied.
Technical specifications
Specification | As published |
Product type | Water bath, 2 L, digital |
Capacity | 2 L |
Chamber material | Stainless steel |
Temperature range | Ambient +5 to 100 degrees C |
Temperature uniformity or accuracy | +/-0.2 degrees C at 37 degrees C |
Temperature increment | 0.1 degrees C |
Display | Large three-digit |
Calibration | In-lab calibration |
Cover | Flat, removable, see-through |
Housing | Insulated, stays cool to the touch |
Chamber dimensions | 5-1/2 in W x 6 in D x 4 in H |
Exterior dimensions | 6-1/2 in W x 8 in D x 6 in H |
Electrical | 115 V |
Weight | 4-1/2 lb |
Supplied from | Ambala, Haryana, India |
This listing publishes a full specification. Confirm the supply voltage before ordering: the published electrical specification is a 110 to 120 V nominal supply, which is not the Indian mains standard; ask whether a 220 to 240 V, 50 Hz version is available for your destination. No tube racks are mentioned as supplied, and wattage, heat-up time and whether a low-water cut-out is fitted are not stated. Confirm these before ordering.
Range and ordering
This item belongs to the Lab Water Baths family within Biotechnology Equipment and Labware, part of the Biotechnology range. Packaged teaching kits are listed under Biotechnology Kits. Bulk, tender and OEM quantities are handled through lab tenders and OEM orders; use the contact page to request a quotation or any specification noted above.